Skip to Main Content
The On-Wall Cable Management System kit includes 3(ea) 18 inch cable covers, 3(ea) 18 inch cable guides, 12 specialty screws, and instructions. Hiding ugly cables in 3 easy steps. The finished install will provide up to 54 inches of on-wall cable management. Take your unorganized wires and cables from this to this.
The tools needed to install the GCM1 are simple, a level or straight edge, a pencil and a light duty screw gun or Phillips screwdriver. Installation is a simple 3 step process. 1, using a level, mark a center line. 2, align the holes on the cable routing wall side unit with the reference line and install the screws. Use caution not to over tighten. 3, route your AV cables and install the covers. That's it, you're done.
If a half length piece will fit better, the GCM1 can easily be separated. Use a razor knife to score the edge for a cleaner snout. The GCM1 can be painted to match the décor of your room or to accent your system. The surface is ready for paint, roll or spray for best results. The cable covers are easily removed and replaced. The GCM1 can be adjusted to meet changes within your AV system or room accents.
The GCM1, On-Wall Cable Management made simple.